G38.3 gives error: "No characters found in reading real value"

More
7 years 2 months ago #142404 by zhivko
G38.3 gives error: "No characters found in reading real value" was created by zhivko
I get "No characters found in reading real value" while using G38.3 in MDI mode.

My MDI command is:
G38.3 Z

My config is in:
github.com/zhivko/PipeCutter/blob/master...achinekit/CRAMPS.ini

What could be wrong?

regards
Zhivko

Please Log in to join the conversation.

More
7 years 2 months ago #142405 by zhivko
Replied by zhivko on topic G38.3 gives error: "No characters found in reading real value"
It works with: G38.3 Z10 F50

Everything OK...
thanks

Please Log in to join the conversation.

More
7 years 2 months ago #142409 by BigJohnT
Replied by BigJohnT on topic G38.3 gives error: "No characters found in reading real value"
From the mighty document for LinxuCNC
linuxcnc.org/docs/2.7/html/gcode/g-code.html#gcode:g38
Code:
It is an error if: the current point is the same as the programmed point. no axis word is used cutter compensation is enabled the feed rate is zero the probe is already in the target state

JT

Please Log in to join the conversation.

More
7 years 2 months ago #142422 by zhivko
Replied by zhivko on topic G38.3 gives error: "No characters found in reading real value"
Thanks John, is it possible to reset parameter
parameters #5061
so I could programmatically see when parameter is set and procedure completed?

Please Log in to join the conversation.

More
7 years 2 months ago #142427 by BigJohnT
Replied by BigJohnT on topic G38.3 gives error: "No characters found in reading real value"
You could use 5070 to test the result of the probe.

JT

Please Log in to join the conversation.

Time to create page: 0.080 seconds
Powered by Kunena Forum