Control Panel Wiring

Never mind.
My English is next level shit SOMETIMES

What is the name of this?
To find on eBay to buy it?

www.google.com/search?q=din+rail+termina...1.9.1373.76lEWZ-IWhU

Din rail terminal block

To drive a motor Fwd and Reverse, if it is a 3-phase motor, you can use 2 3-pole relays.
1 relay is on-off.
The other is used to reverse the motor.
Off Off = Off
Off On = Off
On Off = Fwd
On On = Rev

Is it a three-phase motor?

The same is probably true for a single phase reversible motor, but might need more poles to switch. You need to emulate what the reversing switch does with a relay.

andypugh wrote: To drive a motor Fwd and Reverse, if it is a 3-phase motor, you can use 2 3-pole relays.
1 relay is on-off.
The other is used to reverse the motor.
Off Off = Off
Off On = Off
On Off = Fwd
On On = Rev

Is it a three-phase motor?

The same is probably true for a single phase reversible motor, but might need more poles to switch. You need to emulate what the reversing switch does with a relay.

Yes,it is a 3 phase 1.1hp motor.

From where the on off signals came?

DinukaShehan wrote: From where the on off signals came?

motion.spindle-on
motion.spindle-forward
linuxcnc.org/docs/2.7/html/man/man9/moti....html#SPINDLE%20PINS

(or on LinuxCNC 2.8+
spindle.0.on
spindle.0.forward
linuxcnc.org/docs/2.8/html/man/man9/moti....html#SPINDLE%20PINS )

There many more things.I can not figure out which code to use?
Complicated and some language problems.
There are any simple codes to my configuration?