Anybody using a thermal dynamics CM 52?

It’s not letting me upload a picture
I am using sheetcam and I have it set up on 0/0

Looking at that, X0 Y0 is the bottom left of the square cut.

Do the X and Y DRO's show zero at that position?

Do you have offsets set somewhere?

Can you post the GCode?

I import the gcode then I home the machine to the bottom corner. Do i need to home the torch first then upload the gcode?

After you Home, if the DRO X&Y are zero then that is the position you need the material.

If your material is in a different position you need to jog X & Y to the correct position then "Touch Off" X and Y to that position using the Touch Off button.

Have a look at Coordinates at this link linuxcnc.org/docs/devel/html/plasma/plas...de.html#_coordinates