How to zero coordinates?

More
6 years 11 months ago #149786 by Cranktown
How to zero coordinates? was created by Cranktown
I have a linux cnc set up with plasmac
Was wondering if there is a way to zero the coordinates so I can move where the cut is made much like the 'zero coordinates' button in mach3.
And if so, how could I program one of the custom buttons to do this?
Thanks!

Please Log in to join the conversation.

More
6 years 11 months ago #149787 by Leon82
Replied by Leon82 on topic How to zero coordinates?
You could make an mdi button,

G90 g10 l2 xo yo if I recall. Will write the current position to work offset zero

Please Log in to join the conversation.

More
6 years 11 months ago #149790 by andypugh
Replied by andypugh on topic How to zero coordinates?
Touch-off should do it. Which GUI are you using?

Please Log in to join the conversation.

More
6 years 11 months ago #149792 by phillc54
Replied by phillc54 on topic How to zero coordinates?
This may help. linuxcnc.org/docs/devel/html/plasma/plas...de.html#_coordinates

Please Log in to join the conversation.

More
6 years 11 months ago #149794 by Cranktown
Replied by Cranktown on topic How to zero coordinates?
It says 'p value out of range with g10 l2'

Please Log in to join the conversation.

More
6 years 11 months ago #149795 by Cranktown
Replied by Cranktown on topic How to zero coordinates?
Using gmoccapy, when I try to touch off it says something along the lines of "cant touch off with none or more than one tool selected" (theres only one tool in the table and it is selected) haha

Please Log in to join the conversation.

More
6 years 11 months ago #149796 by Leon82
Replied by Leon82 on topic How to zero coordinates?

Cranktown wrote: It says 'p value out of range with g10 l2'


Add a p1. I havent done in a. While

Please Log in to join the conversation.

More
6 years 11 months ago #149798 by phillc54
Replied by phillc54 on topic How to zero coordinates?
Are you using this button:

Attachment not found


then these buttons:

Attachment not found

Please Log in to join the conversation.

More
6 years 11 months ago #149800 by Cranktown
Replied by Cranktown on topic How to zero coordinates?
None of those, I was trying to use the touch off in the tooleditor page

Please Log in to join the conversation.

More
6 years 11 months ago #149801 by phillc54
Replied by phillc54 on topic How to zero coordinates?
For the PlasmaC config you need to use the above ones, not the tool touchoff.

Please Log in to join the conversation.

Time to create page: 0.092 seconds
Powered by Kunena Forum