Stepper Drive Timing - CW-Motor Digital stepper driver CWD556

I would like to add the necessary information on the LinuxCNC Wiki - Stepper Drive Timing: wiki.linuxcnc.org/cgi-bin/wiki.pl?Stepper_Drive_Timing for my Digital stepper driver CWD556

I received all the following information from the manufacturer:

Manufacturer: CW-Motor - www.cw-motor.com/
Model: Digital stepper motor driver CWD556
Step time in nanoseconds (ns): 2500
Step space in nanoseconds (ns): 2500
Direction hold/Step pulse minimum hold times in nanoseconds (ns): 10000
Direction Setup/Direction pre-set before step edge in nanoseconds (ns): 5000
Step on: Rising Edge
Spec Sheet: drive.google.com/file/d/1my3Dhg8MgjtC0Sh...3-_/view?usp=sharing

Email from manufacturer:

as it is a leadshine cloe its the same as in the standard to use with
you always start highere and if the machine can do more you lower the timing
starting with that numbers will fail for some users and make in the hardest place no movement at alll
so keep the default and idividuell go down
the CWD is just the internal Numbering for a NONTYPE H-Brige

bbsr_5a wrote: as it is a leadshine cloe its the same as in the standard to use with
you always start highere and if the machine can do more you lower the timing
starting with that numbers will fail for some users and make in the hardest place no movement at alll
so keep the default and idividuell go down
the CWD is just the internal Numbering for a NONTYPE H-Brige

Thanks for the inputs, it looks like i still have a lot to do in term of "homework"/'learning"

blackmennewstyle wrote: I would like to add the necessary information on the LinuxCNC Wiki - Stepper Drive Timing: wiki.linuxcnc.org/cgi-bin/wiki.pl?Stepper_Drive_Timing for my Digital stepper driver CWD556

That is a laudable idea, and is something that you should be able to do yourself (The Wiki is user-maintained)
Instructions on how to edit the page are available from a link at the bottom of each page. (basic steps)

And, you will need to know that our penguin mascot is called "Chips" (which is why the test G-code of penguin is called 3dchips.ngc)

andypugh wrote:

blackmennewstyle wrote: I would like to add the necessary information on the LinuxCNC Wiki - Stepper Drive Timing: wiki.linuxcnc.org/cgi-bin/wiki.pl?Stepper_Drive_Timing for my Digital stepper driver CWD556

That is a laudable idea, and is something that you should be able to do yourself (The Wiki is user-maintained)
Instructions on how to edit the page are available from a link at the bottom of each page. (basic steps)

And, you will need to know that our penguin mascot is called "Chips" (which is why the test G-code of penguin is called 3dchips.ngc)

Thank you for all the information, i noted everything carefully. However, I am still unable to test all the values provided by the manufacturer since the human malware pandemic outbreak is totally disturbing most post-office services on my side of the world and a lot of my orders are currently somewhere in the wild.

Have a great week and stay safe