New Mill Build...Can I use LinuxCNC?

More
6 years 1 week ago #186412 by rodw
Replied by rodw on topic New Mill Build...Can I use LinuxCNC?
What voltage are your motors at?

Please Log in to join the conversation.

More
6 years 1 week ago #186413 by Mayberry Customs
Replied by Mayberry Customs on topic New Mill Build...Can I use LinuxCNC?
Just tried these settings...still the same thing. Thanks, Andy

Please Log in to join the conversation.

More
6 years 1 week ago #186415 by Mayberry Customs
Replied by Mayberry Customs on topic New Mill Build...Can I use LinuxCNC?
According to the spec sheet I posted, wired as the middle variance, they are 8.96v if that is what you are referring to. Thanks

Please Log in to join the conversation.

More
6 years 1 week ago #186416 by rodw
Replied by rodw on topic New Mill Build...Can I use LinuxCNC?
What voltaqe power supply for the steppers? 48v, 70v what?

Please Log in to join the conversation.

More
6 years 1 week ago #186417 by Mayberry Customs
Replied by Mayberry Customs on topic New Mill Build...Can I use LinuxCNC?
60v power supply’s, one for each driver. Thanks

Please Log in to join the conversation.

More
6 years 1 week ago #186420 by rodw
Replied by rodw on topic New Mill Build...Can I use LinuxCNC?
Maybe try Peter's wiring suggestion.

Please Log in to join the conversation.

More
6 years 1 week ago #186421 by Mayberry Customs
Replied by Mayberry Customs on topic New Mill Build...Can I use LinuxCNC?
Ok that’s the next thing I will try. Thank you

Please Log in to join the conversation.

More
6 years 1 week ago #186431 by Mayberry Customs
Replied by Mayberry Customs on topic New Mill Build...Can I use LinuxCNC?
Just tried this alternative wiring on one axis, did not make any difference. Thanks

Please Log in to join the conversation.

More
6 years 1 week ago #186438 by PCW
Replied by PCW on topic New Mill Build...Can I use LinuxCNC?
P is set wrong in the ini file. Its set for 10000 which will result in oscillations.
It should be set to 1/servo period or 1000 for a 1 ms (1000000 ns) servo thread
period.

Please Log in to join the conversation.

More
6 years 1 week ago #186439 by Mayberry Customs
Replied by Mayberry Customs on topic New Mill Build...Can I use LinuxCNC?
Ok, can you clarify on how to fix this? Is this a setting in pncconfig or do I go into the .ini file adjust it? Thanks a lot, Andy

Please Log in to join the conversation.

Time to create page: 0.777 seconds
Powered by Kunena Forum