Z axis

More
6 years 5 months ago #166707 by motal2004
Replied by motal2004 on topic Z axis
See picture

Please Log in to join the conversation.

More
6 years 5 months ago #166708 by phillc54
Replied by phillc54 on topic Z axis

motal2004 wrote: I try to open it through a terminal command and I get permission denied. I figure it has something to do with trying with a bash command, how do I go around this. When open linuxcnc my configuration are not showing up either

Can you try again from a terminal and post the errors.

Is this a Buildbot or RIP installation?

Please Log in to join the conversation.

More
6 years 5 months ago #166709 by motal2004
Replied by motal2004 on topic Z axis
So I used this forum
forum.linuxcnc.org/9-installing-linuxcnc...easy-install?start=0

Please Log in to join the conversation.

More
6 years 5 months ago #166710 by phillc54
Replied by phillc54 on topic Z axis
OK, Buildbot. Can you post those errors.

Please Log in to join the conversation.

More
6 years 5 months ago #166711 by motal2004
Replied by motal2004 on topic Z axis
This is what I get from terminal. See picture
I would copy paste but my web browser is saying address unreachable.

Please Log in to join the conversation.

More
6 years 5 months ago #166712 by phillc54
Replied by phillc54 on topic Z axis
You need linuxcnc and a space in front of that.


Edit: something like:
Code:
linuxcnc ~/linuxcnc/configs/azplasma/azplasma.ini

Please Log in to join the conversation.

More
6 years 5 months ago #166713 by motal2004
Replied by motal2004 on topic Z axis
The “~” in The manual threw me off i’m getting somewhere now see picture. I’m trying to find this “in” pin

Please Log in to join the conversation.

More
6 years 5 months ago #166714 by phillc54
Replied by phillc54 on topic Z axis
Can you post that file, you can click attachment at the bottom then drag and drop the file.

Please Log in to join the conversation.

More
6 years 5 months ago #166715 by motal2004
Replied by motal2004 on topic Z axis
connection. hal file

Please Log in to join the conversation.

More
6 years 5 months ago #166716 by phillc54
Replied by phillc54 on topic Z axis
In this line:
Code:
net plasmac:float-switch hm2_7i96.0.gpio.004.in in => debounce.0.0.in
you have an extra "in"

"~" means users home directory

Please Log in to join the conversation.

Time to create page: 0.214 seconds
Powered by Kunena Forum