parallel port no longer detected by LinuxCNC and neither by dmesg, failed?

More
6 years 5 months ago #166748 by gzcwnk
parallel port no longer detected by LinuxCNC and neither by dmesg, failed? was created by gzcwnk
It was working but I tried a new BOB as the one I had was failing and well I am wondering if the new BOB damaged the PP card?

:(

Please Log in to join the conversation.

More
6 years 5 months ago #166749 by tommylight
Replied by tommylight on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
What voltage does the BOB use ?
Is it a PCI add on or built in parallel?

Please Log in to join the conversation.

More
6 years 5 months ago #166750 by gzcwnk
Replied by gzcwnk on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
The Bob has a seperate 24v dc supply. PCI add on card

dmesg (dmesg | grep para) doesnt show a paraport

Please Log in to join the conversation.

More
6 years 5 months ago #166751 by gzcwnk
Replied by gzcwnk on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
Actually sorry my error should be dmesg |grep parp NOT para

so its there just not working?

Please Log in to join the conversation.

More
6 years 5 months ago #166752 by tommylight
Replied by tommylight on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
Insert the card into another PCI slot if available, if not, clean the contacts on the card and motherboard.
And 24V will mess it up if any miss wiring occurred.

Please Log in to join the conversation.

More
6 years 5 months ago #166753 by gzcwnk
Replied by gzcwnk on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
How could I mis-wire it? its optically isolated?

Please Log in to join the conversation.

More
6 years 5 months ago #166757 by tommylight
Replied by tommylight on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
Some yes, some no.

Please Log in to join the conversation.

More
6 years 5 months ago #166758 by gzcwnk
Replied by gzcwnk on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
OK, is it possible the address has moved and linuxCNC cant see it any more?

Please Log in to join the conversation.

More
6 years 5 months ago #166760 by tommylight
Replied by tommylight on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
Yes it is, and to prevent that from happening you have to set the BIOS to manually assign addresses and IRQ.

Please Log in to join the conversation.

More
6 years 5 months ago #166761 by tommylight
Replied by tommylight on topic parallel port no longer detected by LinuxCNC and neither by dmesg, failed?
Did you just post another topic and then delete it ?
It was there, now it is not, something about a Dell 9020 ? :(

Please Log in to join the conversation.

Time to create page: 0.106 seconds
Powered by Kunena Forum