Program will not start

More
6 years 2 months ago #177973 by allenwg2005
Program will not start was created by allenwg2005
Hi Folks,
It's been years sense I needed help but I screwed things up and my LinuxCNC Axis program will not start now.
I hope it's OK to post this question here, if I messed that up I apologize in advance.

Can someone help me sort this problem

Thank you so much.

Attachment not found

Please Log in to join the conversation.

More
6 years 2 months ago #178075 by tommylight
Replied by tommylight on topic Program will not start
From your error log :

Embeded tab command "halcmd loadusr -Wn gladevcp gladevcp -c gladevcp -u python/probe_screen.py -x 73400499 python/probe_icons/probe_screen.glade" exited with error: 1

and
Code:
Can not find -sec APPLICATIONS -var DELAY -num 1 I/O error : Permission denied I/O error : Permission denied I/O warning : failed to load external entity "python/probe_icons/probe_screen.glade"
They all point to a permission problem with one of the files needed.
A wild guess would be that "sudo" was used where it was not supposed to during installation, so you might want to go through the installations steps again and check that.

Please Log in to join the conversation.

More
6 years 2 months ago #178413 by allenwg2005
Replied by allenwg2005 on topic Program will not start
Tommy, Thanks for the direction, that helped me solve this one.

Please Log in to join the conversation.

More
6 years 2 months ago #178414 by tommylight
Replied by tommylight on topic Program will not start
You are welcomed, always.

Please Log in to join the conversation.

Time to create page: 0.182 seconds
Powered by Kunena Forum