- Posts: 19306
- Thank you received: 0
Control panel, MUX wiring help
5 years 8 months ago #197597
by andypugh
Replied by andypugh on topic Control panel, MUX wiring help
Here is the component.
It has a fixed size of 64 as I couldn't get the [64:personality] rubric to work. I thought that it could be a limitation of userspace components, but I am not sure.
There are a lot more possible key events than you might imagine. Some could be fun to code to hard switches: wiki.linuxcnc.org/cgi-bin/wiki.pl?Scancodes
I am about to send it to a test branch to see if it compiles on all platforms.
It has a fixed size of 64 as I couldn't get the [64:personality] rubric to work. I thought that it could be a limitation of userspace components, but I am not sure.
There are a lot more possible key events than you might imagine. Some could be fun to code to hard switches: wiki.linuxcnc.org/cgi-bin/wiki.pl?Scancodes
I am about to send it to a test branch to see if it compiles on all platforms.
Please Log in to join the conversation.
- juliankoenig87
- Offline
- Premium Member
-
Less
More
- Posts: 120
- Thank you received: 0
3 years 1 month ago #281545
by juliankoenig87
Replied by juliankoenig87 on topic Control panel, MUX wiring help
Hi Lois,
I recently bought a Bosch 048016 also. Do you have the manual with further infomation? I cant find any and already searched a while.
Best regards
Julian
I recently bought a Bosch 048016 also. Do you have the manual with further infomation? I cant find any and already searched a while.
Best regards
Julian
Please Log in to join the conversation.
Time to create page: 0.047 seconds
