Set the home pos.

Oops. Sorry to hear that.
But yes you have to make sure you jog the right way.

Rørbæk wrote: Yes there is a override limits used it and smashed the limit switch.

That usually means they are not properly installed.
Machine should have hard stops, not use switches as hard stops.
Limit and home switches must be side mounted with enough "on time" to be properly triggered.

Thanks for all your help untill now.
I am a little bussy here around x mas with other things.
Merry X-mas to you.

Henrik

I have been quite bussy during x-mas time, but i have changed the endswitches and it works, I have a small problem when the mashine hot the hard stops it bach up but not enough whith parameter do i have to change.

Thanks for your help and have happy new year. Henrik see you in 2021.

Not sure what you mean, if the machine hits the end switches outside of the homing process then it should just stop with an error and not backup.

Rørbæk wrote: I have been quite bussy during x-mas time, but i have changed the endswitches and it works, I have a small problem when the mashine hot the hard stops it bach up but not enough whith parameter do i have to change.

HOME_OFFSET =

Here should be a cake with lights in. The machine have made the first cuttings.

A friend with a diff CNC machine was here to help me with Fusion 360 and the mashine.

Nice!

Yes and its thanks to you here.

Hi there
I am back again.
As i have told before we have had the machine up and running but i still have problems with the end stop.
When i am homing the mashine it is running out to the micriswithes stops return a litle and then moves forward and hit the microswitches.
So were do i change so it run out hit the sw. return a couples of mm then go forward and stops before it hit the sw. again.

Happy new year Henrik