multiple motion probe inputs

My shared solution on first page is like relay switch...


M64P1 activate the probe output
M65P1 inhibit touch probe output

I also use a tool length sensor and a touch-probe. Each sensor is connected to a separate input on the Mesa card.
I use the gen_muxeric component to switch between the inputs.

To switch the inputs you need G64P0 and G63P0 in the 3D-Probe macro.

This works with NO and NC. The unused touch probe can be unplugged.


--
Roland

roland wrote: To switch the inputs you need G64P0 and G63P0 in the 3D-Probe macro.
--
Roland

Did you mean M64 M65 ?

with my solution near similar you can also use both sensor at same time ex : probing the toolsetter with the probe (not really needed but really better for security)

And same as you in my macro i usr M64P1 (P2) or M65P1 (P2) for managing one other or both

@roland i will try this, thank you

alkabal, you are right G... is nonsense. Correct is M64 and M65

I was probably still a little too tired when I wrote that

is there any reason for use mux-gen rather than mux2 ?

mux2 works with "float" signals..
we need "bit" signals here. Therefore the config=bb2

Thank you guys very much!
I was able to solve my problem with the method roland provided and alk mentioned earlier

alkabal wrote:
...with my solution near similar you can also use both sensor at same time ex : probing the toolsetter with the probe (not really needed but really better for security)...

Hello alkabal,
I agree.
I have to apologize for my poor English because I unfortunately need a translator.
In my opinion, it is important to have both sensors, the 3D probe (touch probe) and the tool measuring device (toolsetter) active at the same time. This gives you the opportunity to measure the exact position of the tool sensor with the 3D button.
I saw that you are working on a new version "probe-screen-ng".
I think that's great!
Can I make a wish about this?
When you're done with this, could you make a good installation guide for it?
Or maybe program a script for automatic installation?
I am very curious how it will continue.
With best regards from Germany
Peter

Hi

I'm not good for script and doc but yes is will try to enhance that.

My actual fork is near to work fine but is very different than "official" fork, i will need to test all the change done (i hope this evening)

Br