Does linuxcnc support G68 and G69 coordianate rotation codes?

5 years 10 months ago #193477 by oldtech

Does linuxcnc support G68 and G69 coordianate rotation codes? was created by oldtech

I don't see either of these codes listed. Are they supported or are there any plans to support them?

Please Log in to join the conversation.

5 years 10 months ago #193479 by cmorley

Replied by cmorley on topic Does linuxcnc support G68 and G69 coordianate rotation codes?

It doesn't use that G commands but you can rotate the coordinate system around Z with G10 L1/L20

linuxcnc.org/docs/devel/html/gcode/g-code.html#gcode:g10-l2

Please Log in to join the conversation.

Time to create page: 2.150 seconds