AKZ250 lazyboy 77

Good morning all first time poster.

I'm in the middle of building a diy cnc and I'm using a usb AKZ250 controller board and I was wondering if its possible to use linuxcnc with this board it supports mach3 I only paid £25 for the board, but it didn't come with any software.

Any advice would be greatly appreciated
Thanks

LinuxCNC can not work with USB motion controllers, to many reasons for that but mainly latency and timing reliability on USB is terrible.
But it does work with a parallel port, Mesa boards from www.mesanet.com , Pico boards, Ethercat, and some other stuff.