Building a chain driven Plasma table.

Ok I found the problem.
If you reinstall after copying the lvonfogurations. You still have to configure the network manually.

It’s all working now.

So after reinstalling Linuxcnc and Upgrading to linuxcnc 2.9.4 I copied the linuxcnc folder from a backup. Then I configured the network manually and the machine is running.
However if I try to cut anything from conversational I get the following error.

 

If I delete the line containing the line with M190 I can cut without error.

Did I miss something during reinstalllation?


 

I made a new configuration based on the current one and saved it under a different name. On the new one there was no error message.

So in the current configuration I replaced the file called M190 with the new one now everything works.

I just wonder did the M190 file change between version 2.9.2 and 2.9.4 ?