Linuxcnc support

Jmh474
Topic Author
Offline
New Member

5 years 5 months ago #208358 by Jmh474

Linuxcnc support was created by Jmh474

Only a quick one

Dose anyone know if linuxcnc supports the ethernet version of nvem v2 please thanks

Please Log in to join the conversation.

BeagleBrainz
New Member

5 years 5 months ago #208361 by BeagleBrainz

Replied by BeagleBrainz on topic Linuxcnc support

From what I've seen anything external hardware works with Mach3 takes on the role of motion control. Linuxcnc is the motion controller and would not make any sense to off load it to a 3rd party device.

Please Log in to join the conversation.

Time to create page: 0.133 seconds