Setting up debounce.

Hi guys,

I was following some discussions related to "debounce" use in LinuxCNC.
Unfortunately, when using provided examples, I get the error:

Can not find -sec APPLICATIONS -var DELAY -num 1 ...

Attached is my HAL and error..

I would highly appreciate if someone could help

SOLVED

With the help from #linuxcnc (thanks to JT-Shop):

Posted hal file is correct. The problem was hiding in "custom_postgui.hal", where debounce was already initiated for z probe (I downloaded some pyvcp examples from linuxcnc forum (MONSTERV7)). Commenting out "debounce" in custom_postgui.hal solved my problem (here posted hal works with no problem!).

Cheers!