HAL Pin for "Run from here"?

More
4 years 11 months ago #228070 by tom.eagan@integrisgp.com
HAL Pin for "Run from here"? was created by tom.eagan@integrisgp.com
Is there a HAL pin to start a gcode routine from a line number other than the beginning? Similiar to halui.program.run but with the ability to specify a line number?

Please Log in to join the conversation.

More
4 years 10 months ago #228093 by cmorley
Replied by cmorley on topic HAL Pin for "Run from here"?
There is not.

Please Log in to join the conversation.

More
4 years 10 months ago #228125 by tom.eagan@integrisgp.com
Replied by tom.eagan@integrisgp.com on topic HAL Pin for "Run from here"?
Too bad. My reason for asking is that I want to implement a "jog while paused" feature... is there an accepted technique for that? Or are there plans to include that capability in a future software release?

Please Log in to join the conversation.

More
4 years 10 months ago #228126 by tommylight
Replied by tommylight on topic HAL Pin for "Run from here"?
www.youtube.com/results?search_query=linuxcnc+jog+while+paused

Please Log in to join the conversation.

More
4 years 10 months ago #228173 by cmorley
Replied by cmorley on topic HAL Pin for "Run from here"?
There is jog at tool change tricks for AXIS and Qtvcp.
There are also external offset technique.
The videos from Michael H that Tommy also linked to, is another technique that is currently not possible

Please Log in to join the conversation.

More
4 years 10 months ago #228185 by tom.eagan@integrisgp.com
Replied by tom.eagan@integrisgp.com on topic HAL Pin for "Run from here"?
Thank you for your help. Looks like external offsets are the way to go, I'll look into that and see what I can do. Thanks again.

Please Log in to join the conversation.

More
4 years 10 months ago #228243 by tom.eagan@integrisgp.com
Replied by tom.eagan@integrisgp.com on topic HAL Pin for "Run from here"?
I got a jog-while-paused system running based on eoffsets. Works pretty well, and I'm even able to adjust jog speed using the same controls on my GUI as for regular jogging. Thanks again for your help, much appreciated!

Please Log in to join the conversation.

Time to create page: 0.084 seconds
Powered by Kunena Forum