Y Axis Not Homing Correctly

Good Day: (If this is in the wrong spot I apologize)
Just installed Linux CNC and have the axis moving but the Y axis doesn't home correctly.
When I pres Home the axis moves to the limit switch, moves off the limit switch, zeros the display and moves back until the limit switch is made again which doesn't allow me to run any programs since the limit switch is made.
The X axis homes perfect.
Any ideas?
Thanks
 

I would guess that you configured the y axis wrong in the INI.
Please post your config files

Thanks for the quick reply, I have attached my INI file.
I "assume" when you mentioned "confg" files that meant the INI file.
Thanks

INI is probably all we need but it is a blank file.

Trying again, sorry.

I notice in axis 0 vrs axis 1:

axus 0
HOME_SEARCH_VEL = negative
HOME_LATCH_VEL = positive

axis 1
HOME_SEARCH_VEL = negative
HOME_LATCH_VEL = negative

That makes axis1 latch twice.
linuxcnc.org/docs/2.7/html/config/ini-ho...homing-configuration
Was that on purpose?

What is the actual error message?

Re:-
[AXIS_1]
TYPE = LINEAR
HOME = 0.0
MAX_VELOCITY = 2.0
MAX_ACCELERATION = 30.0
STEPGEN_MAXACCEL = 37.5
SCALE = 1600.0
FERROR = 0.05
MIN_FERROR = 0.01
MIN_LIMIT = -0.01
MAX_LIMIT = 12.0
HOME_OFFSET = 0.000000
HOME_SEARCH_VEL = -1.000000 ( the - sign changes the direction of travel)
HOME_LATCH_VEL = -0.312500 ( try removing the - sign then it should reverse the direction of travel)

Not sure why I set it up that way, I changed it in the config and it fixed it (insert face slapping emoji here)
Thanks very much for the help!