plasmacam DHC2

I just recently purchased a Plasmacam DHC2 table i uploaded all the software that came with it to my desktop computer. When i go to the Plasmacam program it doesn't seem to be right. I know it is very outdated (3.02) and I'm not sure where to start to get this up and going. The more I dig into it the more I realized I jumped on it too quick. Is there a way around their controller and program?  Any help or information is appreciated

JDM83 wrote:

Any help or information is appreciated

How about you giving us more information to go on, like PDF if any, pictures of the controller/electronics box, what software does it use ? Or should we run with the assumption that it runs LinuxCNC ? Ok then, what version of LinuxCNC, What GUI? Axis? PlasmaC? QtPlasmaC?

Still all original Plasmacam software and controller. I bought it used and came with the installation discs. I had an older HP desktop with XP that still in good shape. I installed the Axxon LF1119KB PCIe board because it didn't have the port to connect to the controller. I installed it and just cant get it to work. I've read that being the older 3.02 version may be my problem and was wondering what direction I need to take next. Would linuxcnc software help me?

Plasmacam is a proprietory system. The motors use some kind of serial communicatons.
You should approach them to transfer the license to you. Software upgrades are available but costly.

Hi. Are you up and running now? If not, contact us with your details for support.

Thanks
Support [at]softio.com