random fails on latency tests

Is this the RTAI kernel Andy provided for LinuxCNC ?
In that case, there are some tests i did with a bunch of older PC's, it does not work with some of those at all while 3.4.9 works perfectly well.
Latency test would run with results at 0, leme find the link:
forum.linuxcnc.org/18-computer/38838-har...ts-used-pc-s?start=0

Very nice work in that thread you provided!

I copied URLs for that thread and the lcnc-hw related one into my notes. I see the point for resizing windows, but I wonder, isn't that like testing latency while using a sledgehammer against the PC? I mean, I usually try to avoid anything unusual while testing. But, good to know, I will put an eye on that

About that RTAI kernel: yep, I think it is

Not really willing to go into yet another mailing list.

Just post on the LCNC-dev mail. We use a a fork of RTAI for LCNC.

Reported on emc-developers and rtai mailing lists

I can't find your post to the LCNC-dev mail list. Do you recall the date that you posted?

About that RTAI kernel: yep, I think it is

Can you go back and check, it really matters.

Of course, posted on emc-developers (with no subject, my bad) on August, 6, 20:44. Not my best report, really, I see now I was messing two different reports on my mind

Spammer booted.