Linuxcnc shows error in Gcode

More
4 years 3 months ago #247590 by strahlensauger
Linuxcnc shows error in Gcode was created by strahlensauger
Hi everybody,
I drew a part in Freecad and the green lines representing the Gcode in Freecad look right.
When I load the GCode in Linuxcnc there is an error.
 

Attachment not found

 

Attachment not found



Is this a bug in Linuxcnc?
 

Please Log in to join the conversation.

More
4 years 3 months ago #247591 by JT
Replied by JT on topic Linuxcnc shows error in Gcode
No, an arc is not correct in your G code. The error is with your CAM softwaer. Try setting the precision in your CAM software smaller.

JT

Please Log in to join the conversation.

More
4 years 3 months ago #247592 by JT
Replied by JT on topic Linuxcnc shows error in Gcode
linuxcnc.org/docs/stable/html/gcode/g-co...#_center_format_arcs

JT

Please Log in to join the conversation.

Time to create page: 0.072 seconds
Powered by Kunena Forum