SOLVED - 6i25 Can't see swicthes change from test box

HansU
Offline
Platinum Member

4 years 1 month ago #253024 by HansU

Replied by HansU on topic SOLVED - 6i25 Can't see swicthes change from test box

Can't you use an external pull down and disable the internal ones? But I guess you can only disable all internal pull ups and then you have to provide the other pull ups externally as well.

Please Log in to join the conversation.

macsddau@linuxcnc
Topic Author
Offline
Premium Member

4 years 1 month ago #253147 by macsddau@linuxcnc

Replied by macsddau@linuxcnc on topic SOLVED - 6i25 Can't see swicthes change from test box

I don't see these lines in HAL :

Code:

addf hm2_5i25.0.read_gpio servo-thread
addf hm2_5i25.0.write_gpio servo-thread

Aren't they required to get communication ?

Please Log in to join the conversation.

macsddau@linuxcnc
Topic Author
Offline
Premium Member

4 years 4 weeks ago #253172 by macsddau@linuxcnc

Replied by macsddau@linuxcnc on topic SOLVED - 6i25 Can't see swicthes change from test box

macsddau@linuxcnc wrote:
I don't see these lines in HAL :

Code:

addf hm2_5i25.0.read_gpio servo-thread addf hm2_5i25.0.write_gpio servo-thread Aren't they required to get communication ?

Not required. Tested, works without

Please Log in to join the conversation.

macsddau@linuxcnc
Topic Author
Offline
Premium Member

4 years 4 weeks ago #253174 by macsddau@linuxcnc

Replied by macsddau@linuxcnc on topic SOLVED - 6i25 Can't see swicthes change from test box

New test box. Old one was broken inside.

Attachment not found

Please Log in to join the conversation.

macsddau@linuxcnc
Topic Author
Offline
Premium Member

4 years 4 weeks ago #253176 by macsddau@linuxcnc

Replied by macsddau@linuxcnc on topic SOLVED - 6i25 Can't see swicthes change from test box

Mark as solved !

Please Log in to join the conversation.

tommylight
Away
Administrator

4 years 4 weeks ago #253180 by tommylight

Replied by tommylight on topic SOLVED - 6i25 Can't see swicthes change from test box

macsddau@linuxcnc wrote:
Mark as solved !

Done, thank you.

Please Log in to join the conversation.

macsddau@linuxcnc
Topic Author
Offline
Premium Member

4 years 4 weeks ago #253225 by macsddau@linuxcnc

Replied by macsddau@linuxcnc on topic SOLVED - 6i25 Can't see swicthes change from test box

Test box schematics :

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.067 seconds