Servo thread rate too fast

More
3 years 11 months ago #256423 by CNC_ANDI
Servo thread rate too fast was created by CNC_ANDI
Hallo, ich bekomme immer wieder beim öffnen von Probe_basic die Meldung

Attachment not found



mein latency test sieht so aus

Attachment not found



woran liegt das kann ich irgendwas dagegen tun?
ich hab mal verschiedene dateien noch angehangen. 

Please Log in to join the conversation.

More
3 years 11 months ago #256425 by tommylight
Replied by tommylight on topic Servo thread rate too fast
Beim BIOS,
-disable hyperthreading
-disable C states
-disable everything with power saving
-disable turbo
-disable speed step
etc.

Please Log in to join the conversation.

More
3 years 11 months ago #256428 by CNC_ANDI
Replied by CNC_ANDI on topic Servo thread rate too fast
Hello thanks,

but always was disabled in Bios, now changes

i´ve tried isolcpus=1,2,3 too, makes al litte bit of change

Please Log in to join the conversation.

More
3 years 11 months ago #256430 by PCW
Replied by PCW on topic Servo thread rate too fast
Also if your host PC has an Intel Ethernet chip, you must disable IRQ coalescing
(man hm2_eth)

What host hardware do you have and which OS?

(uname -a)

Please Log in to join the conversation.

More
3 years 11 months ago #256431 by CNC_ANDI
Replied by CNC_ANDI on topic Servo thread rate too fast
hello, the uname -a file is in my first post

i dont know what you mean with (man hm2_eth)

how can i disable IRQ coalescing?

it´s a intel i5 quadcore with 16gb of ram and ssd harddrive

Please Log in to join the conversation.

More
3 years 11 months ago #256435 by PCW
Replied by PCW on topic Servo thread rate too fast
OK so you have a Intel MAC which needs to have IRQ coalescing disabled

temporarily, you can try

sudo ethtool -C [ethernet_device_name] rx-usecs 0

Please Log in to join the conversation.

More
3 years 11 months ago #256438 by andypugh
Replied by andypugh on topic Servo thread rate too fast

i dont know what you mean with (man hm2_eth)
He means "type 'man hm2_eth'" at the command line to view the hm2_eth manual pages. 

Alternatively, follow this link:  linuxcnc.org/docs/stable/html/man/man9/hm2_eth.9.html

Please Log in to join the conversation.

More
3 years 11 months ago #256440 by CNC_ANDI
Replied by CNC_ANDI on topic Servo thread rate too fast
ok thanks i have test it and the latency is much better

max 12000 jitter

i will test it few times

Please Log in to join the conversation.

Time to create page: 0.165 seconds
Powered by Kunena Forum