Linuxcnc after cloning the disk with Clonezilla, the motors of the X Y Z no work

I cloned the ATA drive to a new SSD to have a spare, then started linuxcnc and I have no reaction of the X Y Z axis motors.
Interestingly, I checked this new SSD on the second computer, which I have a working linuxcnc with the configuration of the lathe on the SSD and all axle motors don't work for me either
What is wrong ?

More info ...

Sklonowany system to płyta
2.7.14 D945GCLF2D
 

The disk from the linuxcnc machine that I cloned is ATA and the board is GA-7VASFS-FS 60GB

The new drive with which I have such problems is the SSD Patriot P210 128GB

The board to which I mounted the cloned (new) disk is
D945GCLF2D. On the same board (D945GCLF2D) as I mentioned, I have a working linuxcnc 2.7.14 lathe and after connecting this new disk there is this problem.


And I forgot when I have linuxcnc on and how to move the axes
the - or + button changes the position of the axis on the screen (the coordinates of the axis change) but as I wrote earlier, the motors of all axes are stopped.
I have attached pics of my bios settings

Are you using a parallel port?
Assuming you are, so in a terminal:
sudo cat /proc/ioports | grep parport
and
sudo lspci -v | grep par
Paste the results from both drives and both PC's here.

Yes, I use LPT ports.Returns the results of commands. 
 
 

jarcysgru post=259816 identyfikator użytkownika=2779Tak, używam portów LPT. Zwraca wyniki poleceń. 

New computer
 

Attachment not found

Old computer
 

Attachment not found

Change the address in the ini file, one of the PC has a built in parallel port at 0x378 the other has an add on card that should be set st 0x1018

I give a hal file and in it I have port 0x378 set.
This second lathe computer has a second 1018 card for the encoder.