7i76E spindle won't run in reverse

More
3 years 3 months ago #275427 by Dgreilick
7i76E spindle won't run in reverse was created by Dgreilick
I am at a loss. I had someone help me with diagnosing wiring, everything seems to be set up correctly but I get no response on an SxxxM4 command. Any help would be great!
I'm using Linuxcnc 2.8.4
Mesa 7i76E card
Huanyang HY series VFD

 

Please Log in to join the conversation.

More
3 years 3 months ago #275436 by PCW
Replied by PCW on topic 7i76E spindle won't run in reverse
1.net spindle-vel-cmd-rpm => pid.s.command

should be
net spindle-vel-cmd-rpm-abs => pid.s.command

2. Is the VFD programmed for ENABLE/DIRECTION rather than FWD/REV?

Please Log in to join the conversation.

Time to create page: 0.098 seconds
Powered by Kunena Forum