PNC CONFIG- 7I76 PIN NOT SHOWING

I am using 7i92 7i76 7i84.

All connected as per document.

Now, I am getting error report while starting Linuxcnc. Report attached. Hal and INI attached.

Note: I had started this same set up earlier when all digital input and output was unused. The Z axis was connected and working fine. But no pin for 7i76 and 7i84 was shown in halshow.

Request for solution.

Do you have field power (Orange connector) applied to both the 7I76 and 7I84?

Yes, filed power connected. Yellow LEDs are glowing.

Well, the problem solved.

Actually I am using separate VIN (12 VDC) and VFIELD (24 VDC).

Now the GND of both VIN and VFIELD should be sorted and connected. But I was using only VFIELD negative.