REMAP M6 function doesn't work

Hello,
I'd like to start by wishing you a very happy new year.

I tried to work on my cnc this weekend but I ran into a few problems remapping the M6 function.

1st problem :

when I start axis, it tells me some pin doesn't exist ( toolchange_index.hal)

motion.digital-out-04
motion.digital-out-05
motion.digital-in-04
motion.digital-in-05
motion.digital-in-06
motion.digital-in-07
motion.digital-in-08
motion.digital-in-09

then the motion.digital-in/out-00.01.02.03 will not display an error

2nd problem

when axis starts up, it shows me this error below



Hal file


INI file


HAL toolchange file


NGC file



would anyone know where the errors come from?

can you post the pre and post epilog files?

I have just RESOLVED on the error message, I had forgotten to insert a few lines of code in my INI program .

but I still have the same problem with input output M64 M65 M66

in attachments my stdglue.py file

You might need to increase the number of digital I/O:
linuxcnc.org/docs/html/man/man9/motion.9.html

forum.linuxcnc.org/38-general-linuxcnc-q...ng-digital-i-o#33203