using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE

More
2 years 8 months ago #293929 by canagman
using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE was created by canagman
Even with all wiring disconnected to that input.....Linux CNC with Hal meter says its on....
I haven't read anything definitive as an answer....
Ty for any suggestions

Please Log in to join the conversation.

More
2 years 8 months ago #293942 by PCW
Replied by PCW on topic using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE
A few more details would help...

What hardware are you using?

Unconnected inputs may be high,low,
or indeterminate, depending on the hardware.

Please Log in to join the conversation.

Time to create page: 0.072 seconds
Powered by Kunena Forum