Xenetech 13x25 support?

Hi,

I'm new here, and just found out about linuxcnc. I searched the forum, but didn't find any results for xenetch. I'm trying to find a linux based software to setup an old xenetech 13x25 machine we have at work. I'm curious if linuxcnc will work with this machine , or if not, maybe someone can point me toward another solution. 

Thanks in advance for any assistance. 

Pictures? Videos? Smoke signals?
Especially pictures of the electronics and wiring.

Linuxcnc can control almost any machine but its not enough info to help
Steppers/Servos? Photos of drives ?

Sorry for not replying yet. It's been a crazy week. It was hard to find any time to get pictures but here is what I got.  

I know the machine was working and in operation about 5 years ago, and a new trotec was purchased as an upgrade. The old machine has been collecting dust all this time. I just took over the area and thought it would be nice to breathe some life back into the rhing if I can.