1, 10, 100, 1000mil increments

I'm using the axis interface with a Mesa 7i95t.

When I move using G0 or G1 the table moves as expected.

When I move using the +/- on the manual page:
1 yields 1 inch, I was expecting 1 mil
10 yields 10 inch, I was expecting 10 mil
1000 yields 1000mil as expected

Below is section from jeffs-knee1.ini

[DISPLAY]
DISPLAY = axis
EDITOR = geany
PROGRAM_PREFIX = /home/jeff/linuxcnc/nc_files
POSITION_OFFSET = RELATIVE
POSITION_FEEDBACK = COMMANDED
MAX_FEED_OVERRIDE = 1.2
MIN_LINEAR_VELOCITY = 0.0
DEFAULT_LINEAR_VELOCITY = 0.5
MAX_LINEAR_VELOCITY = 1.6
INCREMENTS = 1,10,100,1000 mil
CYCLE_TIME = 0.1
INTRO_GRAPHIC = emc2.gif
INTRO_TIME = 0
OPEN_FILE = ""

Have you tried:

INCREMENTS = 1 mil, 10 mil , 100 mil, 1000 mil

Aciera wrote:

Have you tried:

INCREMENTS = 1 mil, 10 mil , 100 mil, 1000 mil
 

That was it, thanks