Lathe tool changer

More
2 years 7 months ago #296750 by jarcysgru
Lathe tool changer was created by jarcysgru
Hello, I am trying to run a lathe tool changer on a stepper motor as the C axis, plus an actuator controlled by a solenoid valve net actuator => parport.0.pin-01-out motion.digital-out-00

This is net pin sensor <= parport.0.pin-10-in motion.digital-in-00, I don't know what sensor to use and where to assign this pin on the SSK-MB1 board
Płyta główna sterowania CNC - SSK-MB1 - EBMiA.pl

Please Log in to join the conversation.

More
2 years 7 months ago #296763 by jarcysgru
Replied by jarcysgru on topic Lathe tool changer
Moja próbna konfiguracja
tokarki

Attachment not found



Proszę, jak mam z tego korzystać


net czujka <= parport.0.pin-10-in motion.digital-in-00

Please Log in to join the conversation.

More
2 years 7 months ago #297142 by jarcysgru
Replied by jarcysgru on topic Lathe tool changer
Po dodaniu Sieć czujka motion.digital-in-00 <= parport.0.pin10-in
halla zmieniacz działa poprawnie

Please Log in to join the conversation.

More
2 years 7 months ago #297158 by tommylight
Replied by tommylight on topic Lathe tool changer
Djakuju bardzo. :)
Is that correct?

Please Log in to join the conversation.

Time to create page: 0.076 seconds
Powered by Kunena Forum