Wiring VFD to MESA 7i96s

With that setting what is the output voltage
measured from TB2 pin 22 to TB2 pin 23?
 

I check as well in all show

Component Pins:
Owner Type Dir Value Name
29 bit IN FALSE spindle.0.amp-fault-in
29 bit IN TRUE spindle.0.at-speed <== spindle-at-speed
29 bit OUT FALSE spindle.0.brake ==> spindle-brake
29 bit OUT TRUE spindle.0.forward ==> spindle-cw
29 bit I/O FALSE spindle.0.index-enable <=> spindle-index-enable
29 bit IN FALSE spindle.0.inhibit
29 bit IN FALSE spindle.0.is-oriented
29 bit OUT FALSE spindle.0.locked
29 bit OUT TRUE spindle.0.on ==> spindle-enable
29 bit OUT FALSE spindle.0.orient
29 float OUT 0 spindle.0.orient-angle
29 s32 IN 0 spindle.0.orient-fault
29 s32 OUT 0 spindle.0.orient-mode
29 bit OUT FALSE spindle.0.reverse ==> spindle-ccw
29 float IN 0 spindle.0.revs <== spindle-revs
29 float OUT 83.33333 spindle.0.speed-cmd-rps
29 float IN 0 spindle.0.speed-in <== spindle-vel-fb-rps
29 float OUT 5000 spindle.0.speed-out ==> spindle-vel-cmd-rpm
29 float OUT 5000 spindle.0.speed-out-abs ==> spindle-vel-cmd-rpm-abs
29 float OUT 83.33333 spindle.0.speed-out-rps ==> spindle-vel-cmd-rps
29 float OUT 83.33333 spindle.0.speed-out-rps-abs ==> spindle-vel-cmd-rps-abs

Im sorry, it was my mistake actually. I plug in a step gen when i rebuild my electric panel. I was checking it now and plug it into the right spot and it is working now as it should be.... Im sorry, was a nobbie moment 

Glad it's working now.

Im sorry and thank you