new to linux

More
2 years 6 months ago #297662 by jeff.carter@pacificevents.com
new to linux was created by jeff.carter@pacificevents.com
Hello,
I am new to linuxcnc system and want to know how I set my home for Z setting. X and Y work fine. When I home Z then do the tool touch off it rehomes my Z to that depth, thus cutting too deep. What settings do I need to do to keep the Z at my zero home and have the cutter travel down to the top surface to begin the cuts at the programmed depth.
Please help.
Thanks
Jeff

Please Log in to join the conversation.

More
2 years 6 months ago #297670 by jeff.carter@pacificevents.com
Replied by jeff.carter@pacificevents.com on topic new to linux
Also my version is 2.7.4. Can I upgrade pretty easily?

Please Log in to join the conversation.

Time to create page: 0.071 seconds
Powered by Kunena Forum