Hey,
So I have this problem on my lathe where I have those micro limit switches with lever and roller.
And my problem is that the limit switch sets off when I'm jogging or when I run program, it's like in the middle of the travel and it just sets off on its own. I don't remember the exact number of the joint error. Sometimes it sets off like 3-4 times. It triggers, I turn it on, try jogging and after like 1mm it triggers again and sometimes this happens even 4 times... It is really getting on my nerves, doing this every time I use the lathe.
I tried checking if some chips might set it off, but it was clean.
So does this have simple software or code solution, or it might be mechanical? Should I try cleaning the contacts? Or I've been thinking if the vibration could trigger it, but when I jog the vibrations aren't even that noticeable...
I'm going insane over this.
Looking forward to your replies.
