Absolute homing

2 years 4 months ago #303147 by Aciera

Replied by Aciera on topic Absolute homing

I suggest we move the discussion about Ethercat drive homing over to the other thread, as we are starting to run things in parallel here:
forum.linuxcnc.org/ethercat/52968-help-n...c-servo-homing-setup

Please Log in to join the conversation.

2 years 4 months ago #303190 by besriworld

Replied by besriworld on topic Absolute homing

This homing is for absolute encoder (single turn)?
For servo motors with multi-turn absolute encoder linuxcnc just takes current shaft position ?

Please Log in to join the conversation.

Time to create page: 0.031 seconds