Linuxcnc 2.8.4 does not show tandem items.

looks like it will home Z, then, Y, then X

 Bingo, I changed the homing speed and it looked really good.
 Only the issue of homming is still 'strange', sometimes it does homming on the three axes, sometimes it only does it on X and Y.
 I couldn't understand now how to homming each individual axis...

I have another problem, I took two photos:
 One of the computer screen showing linuxcnc with the open G code that is used to machine number 2.
 The second is the drawing I made of how the machine is executing the machining code for number 2, but inverted/mirrored as I made the drawing on paper and positioned it on the machine.
 I tried to change the configuration of the axes and connection of the motors in the drivers and I couldn't solve it.
 Could you help me with this too?
 I needed to make a notch on a piece of acrylic these days and as I no longer had time to deliver the acrylic, I inverted the software that generates the gcode and placed the acrylic more in the middle of the table to make the notch and be able to deliver it.

X axis is backwards, change the direction pin if using wizard, or add/remove - in from of scale/step_scale for the X axis

tommylight wrote:

X axis is backwards, change the direction pin if using wizard, or add/remove - in from of scale/step_scale for the X axis
 

Ahh ok, I'll test it, thanks.

Hi, I did some tests just now, I also ended up inverting the X and Y axis pins in the software and now the machine movement is correct, thanks for the help.