Note: Using POSIX realtime 7167 Stopping realtime threads

More
2 years 4 months ago #303533 by suraj9735
Note: Using POSIX realtime 7167 Stopping realtime threads was created by suraj9735
Getting POSIX realtime error and not able to launch the linuxcnc software.

ip a is ok, showing 10.10.10.100. Ping 10.10.10.10 is also ok, getting response from the board. Using Debian GNU/Linux 12 (bookworm), linuxcnc 2.9.2 with kernal version '6.1.0-21-rt-amd64'.

Is this kernal version is ok or need to install another kernal?
 

Please Log in to join the conversation.

More
2 years 4 months ago #303534 by suraj9735
Replied by suraj9735 on topic Note: Using POSIX realtime 7167 Stopping realtime threads
I have attached error.report file below

Please Log in to join the conversation.

More
2 years 4 months ago #303536 by rodw
Replied by rodw on topic Note: Using POSIX realtime 7167 Stopping realtime threads
Please read the error report caefully.

This is the cause:

CANNOT FIND FILE FOR:try7_mill.hal

Please Log in to join the conversation.

Time to create page: 0.084 seconds
Powered by Kunena Forum