Loosing tool ofrsets when stopping program

Skidloaders1
Topic Author
Offline
Senior Member

2 years 3 months ago #306030 by Skidloaders1

Loosing tool ofrsets when stopping program was created by Skidloaders1

Hi all
Have a lathe with linuxcnc with 2x vertical rotating 4 position tool holders.
When stop or e-stop the program midway a program i loose my tool offsets .
all the tools offsets are reset by the same amount. what could the problem be?

Please Log in to join the conversation.

Aciera
Offline
Administrator

2 years 3 months ago #306060 by Aciera

Replied by Aciera on topic Loosing tool ofrsets when stopping program

What GUI are you using (Axis, Gmoccapy, QtDragon ...)?

Please Log in to join the conversation.

RotarySMP
Offline
Platinum Member

2 years 3 months ago #306071 by RotarySMP

Replied by RotarySMP on topic Loosing tool ofrsets when stopping program

I put a big divet in my mill table due to G43 cancelling on E-stop. Not a fan!

Please Log in to join the conversation.

Aciera
Offline
Administrator

2 years 3 months ago #306076 by Aciera

Replied by Aciera on topic Loosing tool ofrsets when stopping program

all the tools offsets are reset by the same amount.

So do you mean the all tool offsets in the tool table or only the currently active tool offset?

Please Log in to join the conversation.

Time to create page: 0.874 seconds