G53, and G54

Is there is a way to save G53, and G54 after turning the machine off?

Thanks

G53 is your machine reference point that is set during homing.
G54 .. g59 should be saved when you exit linuxcnc. At least that is what happens on my installations.

I dont have homing (I bought the limit switches but did not install them yet )

So every start I have to zero x,y,z and that will be my G53 every time.

What I am doing now is G53 G0 x0 y0 then I shut the machine

next start I will set x, y to zero again to set g53 again. For some reason G54 is saved. But it is useless if G53 is lost.

Thanks

Philip


Edit : 

apology

I just realized that my question has no meaning.

I have to install the limit swiches, be able to home, then G54 will work because it is saved.