radius to end of arc error.

Hello, all I have suddenly been getting numerous errors when trying to run my table. I have tried all the fixes on radius to end of arc errors. I have a suspicion that the recent fusion update may be causing this. I reprocessed an old file I had, and it now also won't cut. is anyone else having issues. 

More info....?

Sorry for the lack of information. my brain went squirrel. so suddenly I don't have any material selection on line 18 of and geode made with fusion. I also have the radius to end of arc differs from radius to start. errors on all the arcs and curves. ill attach a code file that i processed this afternoon. I had no problem making usable code on Tuesday but now i am not having any luck.   . I have not run back to the shop to get my config files downloaded. I don't feel it is a change on the control computer since it is a stand-alone that was working well as of Tuesday. 

I guess I can't attach a copy of my post processor. it is PlasmacV2.1 I don't know if that matters. I have muddled through most of the issues that I have had come up by YouTube and the forum. 

I can load that ngc file in both PlasmaC and QtPlasmaC with no issues.

I see that the PP adds both G90 and G9 to the preamble which are the LinuxCNC defaults.

Could you take a screenshot of the error message so we can see the incorrect values.

ok I went and got my ini file and took a picture of the error message. and will add the file that was with the error message this time around. I may have a setting buggered. it has worked for what I have tried before but I am relatively new at this. 

my 1.3 mb pic won't upload

operation error:
g code error in treecandle3.ngc
near line 152 of 
/tmp/emcflt-tuxqhmgh.d/treescandle3.ngc
radius to end of arc differs from radius to start:
start = (x11.5745.y3.2479) center= (x11.5902.y3.2604)
end = (x11.6001.y3.2834) r1=0.0200 r2=0.0250
abs_err=005033 rel_err=20.1065%

well I turned off merge circle and made a useable code.