Homing of Z Axis is skipped

Hello,
 I have CNC router in the making. Everything is moving, wired properly and all homing switches are signalling  correctly (checked via HAL meter). 

 The problem is, that when I start homing sequence, the Z axis just homes immediately without any movement. Everything goes green and sets the correct Z height, as it would touch the home switch (170mm in my case). Other Axis are working just fine, as the rest of the machine.

 I generated the bulk of the config with PncConfig, but didn't include the Z home switch, as it wasn't connected at that time. Now I went through other axis and copy the missing nets - mainly home-z to the Mesa's input. 

 I must have overlooked something. Can you please check my configuration? Thank you very much in advance.

 

In the ini file, you have to copy the lines under HOME_OFFSET, there are mising entries for home search and latch and final velocities.
Also, home sequence for Z axis is usually 0, not 1, so it homes first and goes up as not to bump into something while other axis are homing.

Yes, that was it! Thank you Tommy.

Martin