Machine moves when you stop program in the middle

Do you have an abort.ngc file in the config?

I have been using the machine for 3 years now. I have even made these parts before. I will post the files in a few.
It does not do this all the time mind you.

Not unless it got there from the easy probe I tried to install.

Thank you for your help, I have had a sick feeling since this started, not because of the lost part but because it didn't seem like I would find the answer. Thank you for helping!!

I think this is all there should be. Maybe more than needed. I will try and get a movie but no promises there.

could you share 'on_abort.ngc'?

I found it finally. I don't see anything in it but here it is. I hope you do. I think I need to try and revert back to before trying to install easy probe.
1- I was unsuccessful in the install (didn't try very hard)
2- not using it since I was unsuccessful
3- never experienced anything like this over the last 12 years or so since finding EMC

If is was something like on abort, shouldn't it do it all the time? I mean like for any program?

Looks fine

If is was something like on abort, shouldn't it do it all the time? I mean like for any program?

Well, yes but since this is an obscure problem it is not likely just related to your hal and ini files.

I think I need to try and revert back to before trying to install easy probe.

Indeed, the easiest would be if you had made a copy of your machine config folder before trying to do the install.

Indeed I wish I had made that copy. But I remember most of the changes. I actually made no changes to .hal or any hal. But changes were made to ini. I can get rid of them.

Does anybody know what this error is? It happens when the machine stops moving after the "random" move.

The distance and direction seems to be related to where the program is in the gcode file.

 

A little more information:
When it is moving on its own, I can not hit pause. Also If i Hit power, it does not respond until the move ends, then the power button is "pressed". Actually it appears all of the GUI is disabled until the move ends. But clicks are stored and executed when it stops moving.

If I hit pause then stop, it will still move.
If I hit pause then power off, It will stay still. Then when I power back on no movement happens. This seems like the work around for now.

Great news I think!!
It seems to be 1 or more of the commented lines here from ini file. I have tested about 10 times with commented it does not move on stop. Without commented it moves when stop is pressed.

I have no idea why, but at least it seems back to proper. The problem is the lines were added to use easy probe. So is there an issue there?