Gmoccapy Toollength sensor routine stops sometimes

Unfortunately that did not work either.

I tried pulling apart the X and Y movement.
It stops at the X movement.
If I put Y first it completes that command but than stops at X.

I just tried it with Axis, and that works like a charm.
So it seems to be only in combination with Gmoccapy.

Anyone any ideas?

You can try remove AUTOMATIC_G43 from gmoccapy.py:
github.com/LinuxCNC/linuxcnc/pull/3113/f...89eab9bcc7a6913808a9