Easy way to compensate skew in X/Y axis ?

Hello all,

By the past I have used millkins to compensate 0.001mm / mm of XY squareness.

Now that I have done a fresh LinuxCNC install, I can't seem to find millkins again, probably way out dated ?

What's the actual way of adding a small skew correction to my axis ?

Is Matrixkins an up-to-date component with LinuxCNC 2.9.3 ? Is it directly embedded in the default installation ?

Thank for your help.

Have a look at this:
forum.linuxcnc.org/49-basic-configuratio...s-xyz?start=0#280714

Aciera wrote:

Have a look at this:
forum.linuxcnc.org/49-basic-configuratio...s-xyz?start=0#280714
 

I should have specified that I am using Basic Probe UI, look like the link you provided me only support Axis ?

EDIT I just tried and it seem to work fine with Basic Probe UI, look like it's working fine. Any warning ? I should be concerned by something ?

Thank you.

the type of gui should not interfere with the kinematics.

I have used Matrixkins and it is very useful, but you need to compile the comp file yourself

Thank you for the info.

I am trying a piece ATM with skewkins (linked above), it look to work fine too.

Less skewing options than matrixkins (I think) but I only needed X/Y skew.