get a bad character '/' on probe macro

I installed a fusion 360 post processor, with probing macros

put the path in linuxcnc, set up the probe and tried to load the circle hole probe. i get bad char '/' near line 27

the macro loads up in linuxcnc and the probe g-code doesn't contain any /, tried a different macro and get the same error

not sure how to trouble shoot this 

ok so i started writing some macros, to test and they all work so the fusion ones i downloaded must be sending the char or returning something wrong

i will keep working on it

got back to this looks like it in the macros, wrote a probe micro and ran it with no problems. guess i need to look at the macros themselves and see if i can find were the '/' is getting sent to the code

went though all the macros and found // comment instead of a () comments
got all the / out and they work. im using tormack probe macros not sure if they work on that system