Recruitment of a consultant for Linux CNC using a Mesa 7i97t board

Hello, I would like to see if anyone can help me with the Linux CNC configuration of a 7i97t Mesa board and a 7i75 board with Chinese T3D servo drivers. I would like to recruit an advisor who could help me and teach me with the configuration. Payment method to be agreed upon.

forum.linuxcnc.org/10-advanced-configura...to-example-mesa-7i77
The same procedure and tuning is valid for 7i97T.
Especially mind the wiring of e-stop and drive enable, those can not be skipped.
-
First you have to get the drives running correctly, with no Mesa and no LinuxCNC. This i can not help with, the rest is quite easy, just follow the above and post here whenever you bump into something strange.

If you are looking for on site assistance, it might help to start with saying where you are located. There are Linuxcnc users all over the world. (And a few might even have spare time to pop in and give you a hand.)

Did you find anyone?
Or did you try yourself?