Halscope trigger level grayed out

When I started halscope, the trigger level slider worked as expected. For some reason it has become non-functional. The slider is gray, no green, no way to adjust it. I've tried restarting halscope and changing trigger channel. It doesn't matter if I'm in Normal or Auto trigger.

Thanks,
Steve

The trigger level is greyed out if the source channel is monitoring a simple bit (on/off) signal or pin. To enable the trigger level slider select a pin or signal that is a float or integer value for the source channel for trigger.

sajurcaju wrote:

When I started halscope, the trigger level slider worked as expected. For some reason it has become non-functional. The slider is gray, no green, no way to adjust it. I've tried restarting halscope and changing trigger channel. It doesn't matter if I'm in Red Light Green Light Normal or Auto trigger.

Thanks,
Steve

Did you make any adjustments to the settings before the trigger level slider became greyed out?

That makes sense Todd. I was thinking of it as an analog scope.

Yes, but that was probably with a different signal line. Also, I killed all the halscope and started over. I think Todd's got the explanation.

Sorry for not responding to these earlier, I thought I had subscribed, but I wasn't getting notifications of your replies.