Proxxon CU4

Didi
Topic Author
Offline
New Member

1 year 6 months ago #326793 by Didi

Proxxon CU4 was created by Didi

Hi,

I'm a newbie on this forum.
Is LinuxCNC compatible with the Proxxon CU4 interface (via parallel port or otherwise)?

Please Log in to join the conversation.

unknown
Offline
Platinum Member

1 year 6 months ago #326794 by unknown

Replied by unknown on topic Proxxon CU4

USB isn't an option.

Parallel port maybe, but you would have to get Proxxon to confirm.

Please Log in to join the conversation.

PCW
Offline
Platinum Member

1 year 6 months ago #326811 by PCW

Replied by PCW on topic Proxxon CU4

Its parallel port compatible (uses the common "Mach 5 Axis BOB" inside)
So would work with a parallel port or Ethernet/SPI/GPIO/etc device that has a
parallel port like interface.

Please Log in to join the conversation.

Didi
Topic Author
Offline
New Member

1 year 6 months ago #326814 by Didi

Replied by Didi on topic Proxxon CU4

In my opinion they are using the "Leadshine DM542EU" stepper motor controllers, but I couldn't identify the BOB. So, thank you for that info.

Please Log in to join the conversation.

Time to create page: 0.093 seconds