Modbus error

1 year 4 months ago #330752 by aluplastvz

Modbus error was created by aluplastvz

When LinuxCNC sends a command to the frequency controller via Modbus RS485, the G-code "freezes" or stops executing commands

Please Log in to join the conversation.

1 year 4 months ago #330773 by PCW

Replied by PCW on topic Modbus error

I don't think you will get much help without a description
of your Modbus hardware and software setup.

Please Log in to join the conversation.

Time to create page: 0.069 seconds